MIL-DTL-8783D
6.2 Acquisition requirements. Acquisition documents should specify the following:
a.
Title, number, and date of this specification.
b.
Applicable specification sheet number, title, and date.
c.
Applicable specification sheet PIN.
Packaging requirements (see 5.1).
d.
6.3 Qualification. With respect to products requiring qualification, awards will be made only for
products which are, at the time of award of contract, qualified for inclusion in Qualified Products List QPL
No.8783 whether or not such products have actually been so listed by that date. The attention of the
contractors is called to these requirements, and manufacturers are urged to arrange to have the products
that they propose to offer to the Federal Government tested for qualification in order that they may be
eligible to be awarded contracts or orders for the products covered by this specification. Information
pertaining to qualification of products may be obtained from Defense Supply Center Columbus, P.O. Box
3990, ATTN: DSCC-VQ, Columbus, Ohio 43218-3990 or emailed to vqp.chief@dla.mil. An online listing
of products qualified to this specification may be found in the Qualified Products Database (QPD) at
6.3.1 Provisions governing qualification (SD-6). Copies of "Provisions Governing Qualification" are
available online at https://assist.daps.dla.mil or from the Standardization Document Order Desk, 700
Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.
6.4 MS21920 PIN's. Former military standard MS21920 has been canceled and superseded by
MIL-DTL-8783/1. PIN's used in MS21920 have been retained in MIL-DTL-8783/1.
6.5 Environmentally preferable material. Environmentally preferable materials should be used to the
maximum extent possible to meet the requirements of this specification. As of the dating of this
document, the U.S. Environmental Protection Agency (EPA) is focusing efforts on reducing 31 priority
chemicals. The list of chemicals and additional information is available on their website
https://www.epa.gov/osw/hazard/wastemin/priority.htm. Use of these materials should be minimized or
eliminated unless needed to meet the requirements specified herein (see section 3).
6.6 Subject term (Keyword) listing.
Duct
Quick release latch
T-Bolt latch
Trunnion
Tube
6.7 Changes from previous issue. Marginal notations are not used in this revision to identify changes
with respect to the previous issue due to the extensiveness of the changes.
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business