MS273950
Size and material code |
v Inches (mm) |
W +.005 (0.13) -.000 Inches (mm) |
|||
CRES |
Al |
CRES |
Al |
||
-3/-4C |
--- |
--- |
--- |
--- |
--- |
-4C |
--- |
--- |
--- |
--- |
--- |
-5C |
--- |
--- |
--- |
--- |
--- |
-6C |
--- |
--- |
--- |
--- |
--- |
-8C |
-80 |
--- |
--- |
--- |
--- |
-10C |
-100 |
--- |
--- |
.420 (10.67) |
.427 (10.85) |
-12C |
-120 |
.625 (15.88) |
±.010 (0.25) |
.500 (12.70) |
.500 (12.70) |
-16C |
-160 |
.670 (17.02) |
.545 (13.84) |
.545 (13.84) |
|
-20C |
-200 |
.695 (17.65) |
.565 (14.35) |
.571 (14.50) |
|
-24C |
-240 |
.795 (20.19) |
.665 (16.89) |
.665 (16.89) |
NOTES:
1. 0imensions are in inches.
2. Metric equivalents are given for information only.
3. Use A dimension when the adjacent diameter to the left of plane B - B is greater than J dimension. When the adjacent diameter is equal to or less than J dimension, M dimension may be used in place of A dimension.
4. Any design of the elbow to the left of plane B - B is acceptable provided the dimensions P and U
and the requirements of this specification sheet and the procurement specification are met.
5. Any forged design is acceptable for sizes -3/-4 through -8.
6. Any bent tube design is acceptable for sizes -10 through -24.
7. The inside diameter (I0) of the elbow, sizes -10 through -24, shall not be less than the I0 of the nipple end of the elbow.
8. Ovality shall not exceed 7.5 percent of nominal tubing outside diameter (O0).
9. Unless otherwise specified, break or radius all corners +.005, -.000 inch (+0.13 -0.00 mm).
10. All diameters within length A plus S must be concentric within .005 inch (0.13 mm) full indicator movement.
11. Remove all burrs and slivers.
12. Surface roughness unless otherwise specified, maximum surface roughness shall not exceed
125µ inch. Ra in accordance with ASME B46.1.
FIGURE 1. Elbow dimensions and configuration - Continued.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business