MS27076E
Size and material code |
L min inch (mm) |
M min (see note 3) inch (mm) |
N dia. inch (mm) |
P dia. inch (mm) |
|||
CRES |
Al |
||||||
-8C |
-80 |
1.030 (26.16) |
.583 (14.81) |
.345 (8.76) |
+.006 (0.15) -.000 |
.497 (12.62) |
+.005 (0.13) -.000 |
-10C |
-100 |
1.130 (28.70) |
.620 (15.75) |
.440 (11.18) |
.586 (14.88) |
||
-12C |
-120 |
1.240 (31.50) |
.720 (18.29) |
.560 (14.22) |
.674 (17.12) |
||
-16C |
-160 |
1.340 (34.04) |
.796 (20.22) |
.828 (21.03) |
1.001 (25.43) |
+.008 (0.20) -.000 |
|
-20C |
-200 |
1.570 (39.88) |
.846 (21.49) |
1.058 (26.87) |
1.255 (31.88) |
+.005 (0.13) -.000 |
|
-24C |
-240 |
1.720 (43.69) |
1.000 (25.40) |
1.282 (32.56) |
+.005 (0.13) -.000 |
1.490 (37.85) |
|
NOTES:
1. 0imensions are in inches.
2. Metric equivalents are given for information only.
3. Use A dimension when the adjacent diameter to the left of plane B-B is greater than the J dimension. When the adjacent diameter is equal to or less than the J dimension, the M dimension may be used in place of the A dimension. 0imension A or M is not applicable to
one-piece nipple design.
4. Any design of nipple components to the left of plane B-B is acceptable provided the nipple is a one-piece design, and the dimensions B and F and the requirements of this specification sheet and the procurement specification are met.
5. Unless otherwise specified, break or radius all corners .005, +.005, -.000 inch (0.13, 0.13,
-0.00 mm).
6. All diameters must be concentric within .005 inch (0.13 mm) full indicator movement.
7. Surface roughness. Unless otherwise specified, maximum surface roughness shall not exceed
125 ยตin. Ra in accordance with ASME B46.1.
8. Remove all burrs and slivers.
FIGURE 1. Nipple illustration - Continued.
REQUIREMENTS
Nipple illustration. See figure 1.
Intended use. This part is a component of MS27062. This is a design standard for manufacturing purposes. The item is only procured as an integral part of adapter assemblies.
Materials. Material and material codes see table I.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business