MS24591D
Dash number |
K |
L |
M |
N |
P |
Q |
S |
T |
U |
inches (mm) |
inches (mm) |
inches (mm) |
inches (mm) |
inches (mm) |
inches (mm) |
inches (mm) |
|||
-16 |
.300 (7.62) |
.280 (7.11) .270 (6.86) |
20° |
15° |
.062 (1.57) .032 (.81) |
.046 (1.17) .016 (.41) |
.0575 (1.46) |
.166 (4.22) |
.000 (.00) |
-20 |
.350 (8.89) |
.255 (6.48) .245 (6.22) |
.077 (1.96) .047 (1.19) |
.0625 (1.59) |
|||||
-24 |
.000 |
.455 (11.56) .445 (11.30) |
8° |
25° |
|||||
-32 |
.250 (6.35) |
.520 (13.21) .480 (12.19) |
12.5° |
15° |
.070 (1.78) .030 (.76) |
.050 (1.27) .010 (.25) |
.0620 (1.57) |
.200 (5.08) |
.022 (.56) .012 (.30) |
Dash number |
v inches (mm) |
w |
x LH-Round thread (see note 7) |
Y (see note 7) |
PD |
z inches(mm) |
-16 |
.031 (0.79) |
3.5° |
1.290-6 |
1.0625-18 UNEF-28 |
--- |
.109 (2.77) .079 (2.01) |
-20 |
4° |
1.555-6 |
1.3125-18 UNEF-28 |
--- |
.140 (3.56) .110 (2.79) |
|
-24 |
4.5° |
1.800-6 |
1.5625-18 UNEF-28 |
--- |
.156 (3.96) |
|
-32 |
.018 (0.46) |
2.285-5 |
2.0000-18 UNS-28 |
1.9706 1.9639 |
.180 (4.57) .140 (3.56) |
NOTES:
1. Dimensions are in inches
2. Metric equivalents are for information only.
3. Thread marks on diameter G shall not be cause for rejection.
4. Unless otherwise specified, tolerances are as follows: angles ±1°, decimals ±.005 inch (0.13 mm).
5. 8reak all sharp edges and remove all burrs and slivers.
6. Unless otherwise specified, maximum surface roughness shall be 125 µin Ra in accordance with
ASME 846.1.
7. Except round threads, threads shall be in accordance with MIL-S-7742.
8. Part or Identifying Number (PIN).
FIGURE 1. Socket dimensions and configuration - Continued.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business