MIL-DTL-5513D
SAE INTERNATIONAL
SAE-AS604
-
Hose Assembly, Polytetrafluoroethylene, Metallic Reinforced, 3000 psi, 400 °F,
Heavyweight, Hydraulic
SAE-AS1339
-
Hose Assembly, Polytetrafluoroethylene, Metallic Reinforced, 3000 psi, 400
Degrees Lightweight, Hydraulic and Pneumatic
SAE-AS4841
-
Fittings, 37° Flared, Fluid Connection
SAE-AS4395
-
Fitting End, Flared, Tube Connection, Design Standard
SAE-AS4396
-
Fitting, End, Bulkhead, Flared Tube Connection, Design Standard
SAE-AS8775
-
Hydraulic System Components, Aircraft and Missiles, General Specification For
SAE-AS18280
-
Fittings, 24° Cone Flareless, Fluid Connection, 3000 psi
SAE-AS33514
-
Fitting End, Standard Dimensions for Flareless Tube Connection and Gasket
Seal
SAE-AS33515
-
Fitting End, Standard Dimensions For Bulkhead Flareless Tube Connections
(Available from SAE International, 400 Commonwealth Drive, Warrendale, PA 15096-0001, Tel: 877-
606-7323 (inside USA and Canada) or 724-776-4970 of these documents (outside USA), www.sae.org.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict
between the text of this document and the references cited herein, the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), samples shall be subjected to first article inspection in
3.2 Materials. Materials used in the manufacture of swivel joints shall be of high quality, suitable for
the purpose intended, and shall conform to applicable Government specifications. Materials conforming
to industry or contractor specifications may be used provided the specifications are satisfactory to the
Government and contain adequate provisions for testing. The use of these specifications shall not
constitute waiver of Government inspection.
3.2.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials shall be used to the maximum extent possible provided that the
material meets operational and maintenance requirements, and promotes economically advantageous life
cycle costs.
3.2.2 Hazardous substances. The use of hazardous substances, toxic chemicals, or ozone depleting
chemicals (ODCs) shall be avoided whenever possible.
3.2.3 Corrosion protection. All metals used on the construction of swivel joints shall be suitably
protected to resist corrosion in accordance with SAE-AS8775 or MIL-H-8890, as applicable.
3.2.4 Dissimilar metals. Contact between dissimilar metals, as defined by MIL-STD-889, especially
brass, copper, or steel, in contact with aluminum or magnesium alloys, shall be avoided wherever
possible. Dissimilar metals shall not be used in intimate contact with each other unless protected against
electrolytic corrosion.
3.2.5 Flared tube connecting end materials. Materials for flared tube connecting ends shall be in
accordance with SAE-AS4841 and 3.2.5.1.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business