MIL-DTL-32480/5
Y Hex
Tube OD
M
N
Dash
Across flats
nom.
inches (mm)
inches (mm)
size
+.0, -.03
inches (mm)
±.04 (1.0)
±.04 (1.0)
(+.0, -0.8)
-4
.2500 (6.350)
.4375 (11.113)
.720 (18.29)
1.732 (44.00)
-6
.3750 (9.525)
.5625 (14.285)
.830 (21.08)
1.909 (48.50)
-8
.5000 (12.700)
.7500 (19.050)
.980 (24.89)
2.008 (51.00)
-10
.6250 (15.875)
.8750 (22.225)
1.110 (28.19)
2.224 (56.50)
-12
.7500 (19.050)
1.0625 (26.988)
1.280 (32.51)
2.382 (60.50)
-16
1.0000 (25.400)
1.3125 (33.338)
1.470 (37.34)
2.559 (65.00)
-20
1.2500 (31.750)
1.6250 (41.275)
1.590 (40.39)
2.638 (67.00)
-24
1.5000 (38.100)
1.8750 (47.625)
1.780 (45.21)
2.638 (67.00)
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Break all sharp edges and remove all burrs and slivers.
4. Dimensions and tolerances not shown shall be in accordance with the following:
a. SAE AS4375 style G for flareless end.
b. SAE J1453-3*520801* for ORFS bulkhead.
c. SAE J1453-3*520118* bulkhead locknut.
FIGURE 1. 45° elbow, flareless to bulkhead ORFS adapter - Continued.
REQUIREMENTS:
Fittings shall be as specified on figure 1 and in table I.
Materials and finishes shall be in accordance with MIL-DTL-32480.
Material and finish designators. Material and finish designators shall be as specified in table I. All
platings shall be capable of meeting a minimum of 96 hours salt spray test in accordance with
ASTM B117. The fittings shall show no evidence of corrosion after 96 hours of salt spray. Fluid
passages, other openings, and internal threads shall not be subject to the plating thickness
requirement and may have bare areas provided they are protected with a light film of oil.
Dimensions. All dimensions not specified on figure 1 shall be in accordance with SAE AS4375 for the
flareless end, SAE J1453-3 for the ORFS end and SAE J514 for the body.
Across flat widths. Across flat widths shall fit standard wrench openings.
Across flat widths shall be in accordance with applicable style code SAE J514 45º elbow.
Inside diameter. The inside diameter shall be in accordance with SAE AS4375 for the flareless end
and SAE J1545-3 for the ORFS end, drill depth shall be optional with manufacturer. Wall thickness
shall be in accordance with SAE AS4375 for the flareless end and SAE J1453-3 for the ORFS end.
Body thickness. The radius and body thickness shall conform to SAE J514.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business