MIL-DTL-25677E
SAE INTERNATIONAL
SAE-AMS-2472
-
Anodic Treatment of Aluminum Alloys Sulfuric Acid Process, Dyed
Coating
SAE-AS3209
-
Packing, Preformed - AMS7276, `O' Ring
SAE-AS4273
-
Fire Testing of Fluid Handling Components for Aircraft Engines
and Aircraft Engine Installations
SAE-AS4396
-
Fitting End-Bulkhead Flared Tube, Connection, Design, Standard
(DoD adopted)
SAE-AS8879
-
Screw Threads-UNJ Profile, Inch
SAE-AS29523
-
Hook, Filler Cap Chain
SAE-AS29561
-
Packing, Preformed, "O" Ring, Synthetic Lubricant Resistant
SAE-AMS-QQ-P-416
-
Plating, Cadmium Electrodeposited
SAE-AMS2700
-
Passivation of Corrosion Resistant Steels
(Copies of these documents are available from www.sae.org or SAE International, 400
Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein (except for related specification sheets), the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in
accordance with the applicable specification sheet. In the event of any conflict between the requirements
of this specification and the specification sheet, the latter shall govern.
3.2 Qualification. Adapters, nozzles, pressure caps, and dust caps furnished under this specification
shall be products that are authorized by the qualifying activity for listing on the applicable qualified
3.2.1 Quality.
3.2.1.1 Statistical process control (SPC). The contractor shall implement and use statistical process
control (SPC) techniques, when possible, in the manufacturing of parts covered by this specification.
Where SPC cannot be utilized because of non-continuous production, a lot sampling plan for inspection
with C = 0 (accept on zero defects) may be utilized. The SPC and C = 0 programs shall be documented
and maintained as part of the overall reliability assurance program. Evidence of such compliance shall
be verified by the qualifying activity as a prerequisite for qualification, effective 24 months after the date of
this document. Dimensioning and tolerancing shall be in accordance with ASME Y-14.5M.
3.3 Materials. Materials shall be as identified herein or as approved by the qualifying activity.
However, when a definite material is not specified, a material shall be used which will enable the
adapters, nozzles, pressure caps, and dust caps to meet the requirements of this specification.
Acceptance or approval of any constituent material shall not be construed as a guarantee of acceptance
of the finished product.
3.3.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible, provided that the
material meets or exceeds the operational and maintenance requirements, and promotes economically
advantageous life cycle costs.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business