MIL-DTL-1213F
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and
handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the
issues of these documents are those cited in the solicitation or contract.
FEDERAL SPECIFICATIONS
FED-STD-H28/1
-
Screw Thread Standards for Federal Services (Section 1) Nomenclature,
Definitions and Letter Symbols for Screw Threads
FED-STD-H28/7
-
Screw Thread Standards for Federal Services (Section 7) Pipe Threads,
General Purpose
DEPARTMENT OF DEFENSE SPECIFICATIONS
MS35758
-
Cups, Grease, Manual Feed
MS35759
-
Cups, Grease, Automatic Feed
DEPARTMENT OF DEFENSE STANDARD
MIL-STD-129
-
Marking for Shipment and Storage
(Copies of these documents are available online at https://quicksearch.dla.mil or from the
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-
5094.)
2.3 Order of precedence. Unless otherwise noted herein or in the contract, in the event of a conflict
between the text of this document and the references cited herein (except for related specification
sheets), the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS.
3.1 First article. When specified (see 6.1), samples shall be subjected to first article inspection in
accordance with 4.4.
3.2. Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible provided that the
material meets or exceeds the operational and maintenance requirements, and promotes economically
advantageous life cycle costs.
3.2.1 Hazardous substances. The use of hazardous substances, toxic chemicals, or ozone depleting
chemicals shall be avoided, whenever feasible.
3.3 Design.
3.3.1 Material. The greases cups shall be made of materials shown on MS35758 and MS35759.
3.3.2 Manual feed (Type I). The design of manual feed grease cups shall be as specified in
MS35758. Cups shall be provided with a knurled edge.
3.3.2.1 Ratchet design. MS35758 may have either a ratchet design or without ratchet.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business