INCH-POUND
MIL-DTL-1213F
13 December 2013
SUPERSEDING
MIL-C-1213E
22 January 1986
MILITARY SPECIFICATION
CUPS, GREASE
Inactive for new design
after 5 April 1999
This specification is approved for use by all Departments and
Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers general requirements for cups, grease used as containers to
distribute lubricant material to moving metal parts in order to reduce friction.
1.2 Classification part. Pumps fabricated to this specification are classified as follows:
1.2.1 Part or Identifying Number (PIN). PINs to be used cups, grease acquired to this specification is
created as follows:
MS
35758
-6
N
Finish
Size dash number
Specification sheet number
MS prefix
2. APPLICABLE DOCUMENTS
specification. This section does not include documents cited in other sections of this specification or
recommended for additional information or as examples. While every effort has been made to ensure the
completeness of this list, document users are cautioned that they must meet all specified requirements
2.2 Government documents.
Beneficial comments, recommendations, additions, deletions, clarifications, etc., and any data that may
improve this document should be sent to: DLA Land and Maritime, ATTN: VAI, P.O. Box 3990, Columbus
OH143218-I39codes:email fluidflow@.dla.mil. Since contact information can change you may want to verify
.2.2 P N 90, or
the currency of the address information using the ASSIST Online database at https://assist.dla.mil/.
AMSC N/A
FSC 4730
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business