A-A-59000A
ASTM (Continued)
ASTM B 505
- Standard Specification for Copper-Base Alloy
Continuous Castings.
ASTM B 584 - Standard Specification for Copper Alloy Sand
Castings for General Applications.
ASTM D 3951 - Commercial Packaging, Practice for.
ASTM F 467 - Standard Specification for Nonferrous Nuts for
General Use.
ASTM F 468 - Standard Specification for Nonferrous Bolts,
Hex Cap Screws, and Studs.
(Application for copies should be addressed to the American Society for
Testing and Materials, 100 Barr Harbor Drive, West Conshohocken, PA 19428-
2859.)
FLUID CONTROL INSTITUTE (FCI)
78-1 - Pressure Rating Standard for Pipeline Strainers Other
Than "Y" Type.
(Application for copies should be addressed to the Fluid Control
Institute, Inc., P.O. Box 3854, Tequesta, FL 33458.)
INSTRUMENT SOCIETY OF AMERICA (ISA)
S75.02 - Control Valve Capacity Test Procedure.
(Application for copies should be addressed to the Instrument Society of
America, 67 Alexander Dr., P.O. Box 12277, Research Triangle Park, NC 27709.)
(Non-Government standards and other publications are normally available
from the organization that prepares or distributes the documents. These
documents also may be available in or through libraries or other informational
services.)
7.2.3 Order of precedence. In the event of a conflict between the text of
this commercial item description and the references cited herein, the text of
this commercial item description takes precedence. Nothing in this commercial
item description, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
7.3 Technical manuals. The requirement for technical manuals should be
considered when this commercial item description is applied to a contract. If
technical manuals are required, military specifications and standards which
have been cleared and listed in DoD 5010.12-L (AMSDL) must be listed on a
separate CDRL (DD Form 1423), included as an exhibit to the contract. The
technical manuals must be acquired under a separate contract line item in the
contract.
7.4 Ordering spare or repair parts. When ordering spare parts or repair
parts for the equipment covered by this commercial item description, the
contract should state that such spare parts and repair parts should meet the
same requirements and provisions as the parts used in the manufacture of the
equipment. Packaging for such parts should also be specified.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business