MS28746E
REQUIREMENTS:
Dimensions and configurations: The design, construction, and physical dimensions shall be in accordance with MIL-DTL-5070 and figure 1 in case of conflict between this drawing and
MIL-DTL-5070, this drawing shall govern.
Materials: Shall be in accordance with MIL-DTL-5070. Finish: Shall be in accordance with MIL-DTL-5070.
PIN example:
MS 28746 -24 CZ
Material/finish designator, see table I Dash number on figure 1
Specification number
MS prefix
TABLE I. Code for material and finish. 1/
Code |
Material/finish |
CC |
Carbon Steel - cadmium plating |
CZ |
Carbon steel - zinc plating |
SS |
Corrosion resistant steel - N/A |
TA |
Titanium - anodized or fluoride phosphated. |
1/ Finishes "CC", "CZ" and "SS" are applicable only to
flange, nipple, and shoulder made of steel alloy. No mixing of steel material/finish types shall be allowed.
To the users of this document, it is recommended that the use of carbon steel material with cadmium plating be used only when the other materials and finishes specified in this document cannot meet performance requirements.
Identification of product. The PIN and the manufacturer's Commercial and Government Entity (CAGE) Code or trademark shall be permanently marked on the flange or on a removable tag securely attached to the flange.
Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue, due to the extent of the changes.
Referenced documents. This document references MIL-DTL-5070.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business