MS28746E
Dash number |
Tubing OD inch (mm) |
A max inch (mm) |
B max inch (mm) |
C inch (mm) |
D dia inch (mm) |
E max dia inch (mm) |
F (see note 7) inch (mm) |
Weight (approx.) pounds (kg) |
-24 |
1.500 (38.10) |
4.047 (102.79) |
1.844 (46.84) |
.812 (20.62) |
1.281 (32.54) |
2.188 (55.58) |
.625 (15.88) |
1.013 (0.46) |
-32 |
2.000 (50.80) |
4.859 (123.42) |
2.250 (57.15) |
.953 (24.21) |
1.750 (44.45) |
2.625 (66.68) |
.875 (22.23) |
1.264 (0.57) |
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Unless otherwise specified, tolerances are as follows: angles ±.5°; decimals ±.005 inch (0.13 mm).
4. If width diametrically across flats or hex is less than the body diameter, the flats or hex shall extend the full length of the body.
5. Diameters after plating must be concentric with each other within .005 inch (0.13 mm) total indicator reading.
6. The manufacturer's Part or Identifying Number (PIN) and CAGE Code shall be permanently marked on the body.
7. Hex or flats shall fit standard wrench openings.
8. Break all sharp edges and remove all hanging burrs and slivers that might become dislodged under usage.
FIGURE 1. Flange dimensions and configuration - Continued.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business