MS27626B
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Unless otherwise specified, tolerances for three place decimals are ±.005 inch (0.13 mm).
4. Radius or break all corners to .005 +.005/-.000, unless otherwise specified.
5. Surface roughness, in accordance with ASME B46.1, shall not exceed 125 µin Ra, unless otherwise specified.
6. In area X, a solid-film lubricant shall be used as specified in MIL-PRF-46010 or SAE-AS5272. Solid-
film lubricant shall be allowed in area Y. Solid-film lubricant shall not extend beyond area Z.
7. For dimension C, use commercial stock size tolerances as specified in SAE-AMS2241.
8. Dimensioning and tolerancing are in accordance with ASME Y14.5M.
9. All burrs and slivers shall be removed.
FIGURE 1. Flared, nipple dimensions and configuration - Continued.
REQUIREMENTS:
Dimensions and configurations: The design, construction, and physical dimensions shall be in accordance with MIL-DTL-83296 and figure 1, in case of conflict between this specification sheet and MIL-DTL-83296, this specification sheet shall govern.
This is a design specification sheet for manufacturing purposes. The item is only procured as an integral part of adapter assembly MS27619.
This part is for use with MIL-DTL-83298 hose and hose assemblies in accordance with
MIL-DTL-32330.
Material: Material shall be corrosion resistant steel (CRES), class 304, condition B (accepted classes only), as specified in ASTM A276 or ASTM A473, with minimum yield of 70,000 psi (483 MPa) for sizes -4C, -6C, and -8C and a minimum yield of 60,000 psi (552 MPa) for size -10C.
Finish: Finish shall be passivated in accordance with MIL-DTL-83296. PIN example:
MS27626 -4 C
Material (C for CRES)
Dash size (see figure 1)
Specification sheet number
MS prefix
PIN example: MS27626-4C indicates a nipple 1/4 inch, CRES.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business