MS27625C
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are for information only.
3. Unless otherwise specified all tolerances shall be ± .005 inch (0.13 mm).
4. Wire shall be straight within .020 inch (0.51 mm) full indicator movement.
5. Unless otherwise specified radius shall be concentric to wire OD within .005 inch (0.13 mm) full indicator movement.
6. Unless otherwise specified radius or break all corners to .005 +.005/-.000 inch (0.13 + 0.13/-.000 mm).
7. Radius shall be concentric to wire OD within .005 inch (0.13 mm) full indicator movement.
8. Surface roughness, as specified in ASME 846.1, shall not exceed 125µ inches (3.18 µm) nominal roughness average (Ra).
FIGURE 1. Retainer wire dimensions and configuration - Continued.
REQUIREMENTS:
Dimensions and configurations shall be as specified on figure 1. This is a design specification sheet for manufacturing purposes.
This specification sheet describes retainer wire used with MIL-DTL-83298 hose and MIL-DTL-32330 hose assemblies. Next assemblies are MS27620, MS27621, MS27633, and MS27634. The item is only procured as an integral part of an adapter assembly.
Material shall be a corrosion resistant steel (CRES), class 304 or 305, condition A in accordance with
ASTM A313/A313M or ASTM A580/A580M.
Finish: Retainer wire shall be passivated in accordance with SAE-AMS2700. Dry-film lubricant shall be in accordance with MIL-PRF-46010 or SAE-AS5272.
PIN:
MS27625 -4 C
Material (C for CRES)
Dash size (see figure 1)
Specification sheet number
MS prefix
PIN example: MS27625-4C indicates a wire, retainer .080 inch diameter, CRES.
Changes from previous issue. Marginal notations are not used in this revision to identify changes due to the extent of the changes.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business