MS27239E
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are for information only.
3. Unless otherwise specified, tolerances are as follows: Angles ±.5°; decimals ±.005 inch (0.13 mm).
4. Unless otherwise specified, maximum surface roughness shall be 125 µin Ra in accordance with
ASME 846.1.
5. Unless otherwise specified, all outside diameters within this length shall be concentric within .005 inch (0.13 mm) total indicator reading.
6. Hole shall be concentric with external taper within .005 inch (0.13 mm) total indicator reading for a depth of .12 inch (3.0 mm) for a depth of .12 inch (3.05 mm).
7. Threads shall be in accordance with MIL-S-7742.
8. Threads shall be in accordance with ASME 81.1 (UNS).
9. 8reak all sharp edges and remove all burrs and slivers.
FIGURE 1. Nipple dimensions and configuration - Continued.
REQUIREMENTS:
Dimensions and configurations: The design, construction, and physical dimensions shall be in accordance with MIL-DTL-5070 and figure 1 in case of conflict between this drawing and
MIL-DTL-5070, this drawing shall govern.
Intended use. This item shall not be procured for stocking purposes. This part is a component of
MS27223, MS27225, MS27227, and MS27229.
Materials: Materials shall be in accordance with MIL-DTL-5070. Finish: Finish shall be in accordance with MIL-DTL-5070.
Color identification: Color identification shall be in accordance with MIL-DTL-5070.
Part or Identifying Number (PIN) example:
MS 27239 -4 CZ
Material/finish code see table I
Dash number on figure 1
Specification number
M prefix
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business