MS27237F
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are for information only,
3. Unless otherwise specified, tolerances are as follows: angles ±.5°; decimals ±.005 inch (0.13 mm).
4. Break or radius all corners .010/.005 inch (max./min.) (0.25/0.13 mm (max./min.)).
5. All diameters shall be concentric within .010 inch (0.25 mm) total indicator reading.
6. Unless otherwise specified, maximum surface roughness shall be 125 µin Ra in accordance with
ASME B46.1.
7. Break all sharp edges and remove all burrs and slivers.
FIGURE 1. Shoulder dimensions and configuration - Continued.
REQUIREMENTS:
Dimensions and configurations: The design, construction, and physical dimensions shall be in accordance with MIL-DTL-5070 and figure 1 in case of conflict between this drawing and
MIL-DTL-5070, this drawing shall govern.
Intended use. This part is a component of MS27227 and MS27229. This item shall not be procured for stocking purposes.
Material: Aluminum shall be in accordance with MIL-DTL-5070. Finish: Finish shall be in accordance with MIL-DTL-5070.
Color identification: Color identification shall be in accordance with MIL-DTL-5070.
Part or Identifying Number (PIN) example:
MS 27237 -16 AA
Material/finish code, see table I Dash number on figure 1
Specification number
MS prefix
TABLE I. Code for material and finish.
Code |
Dash size |
Material/finish |
AA |
-8 through -48 |
Aluminum - anodic coating |
Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue, due to the extent of the changes.
Referenced documents. In addition to MIL-DTL-5070, this document references the following:
MS27227
MS27229
ASME B46.1
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business