MS27231B
MS27231 dash number |
A (ref) inches (mm) |
B ±.010 (0.25) inches (mm) |
c ±.020 (0.51) inches (mm) |
D inches (mm) |
E Dia inches (mm) |
-8 |
2.750 (69.85) |
1.125 (28.58) |
.810 (20.57) |
.561 (14.25) |
.360 (9.14) .355 (9.02) |
-10 |
2.925 (74.30) |
.687 (17.45) |
.460 (11.68) .450 (11.43) |
||
-12 |
3.219 (81.76) |
.875 (22.23) |
.582 (14.78) .576 (14.63) |
||
-16 |
2.723 (69.16) |
1.125 (28.58) |
.820 (20.83) .810 (20.57) |
||
-20 |
2.896 (73.56) |
1.375 (34.93) |
1.052 (26.72) 1.042 (26.47) |
||
-24 |
2.873 (72.97) |
1.062 (26.97) |
.750 (19.05) |
1.625 (41.28) |
1.286 (32.66) 1.276 (32.41) |
-32 |
3.507 (89.08) |
1.241 (31.52) |
.940 (23.88) |
2.125 (53.98) |
1.755 (44.58) 1.745 (44.32) |
-40 |
3.844 (97.64) |
1.375 (34.93) |
1.060 (26.92) |
2.625 (66.68) |
2.219 (56.36) 2.199 (55.85) |
-48 |
3.250 (82.55) |
2.823 (71.70) 2.803 (71.20) |
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Unless otherwise specified tolerances are ±.005 inch (0.13 mm).
4. Unless otherwise specified, maximum surface roughness shall be 125 µin Ra in accordance with
ASME B46.1.
5. Shoulder end F shall be in accordance with MS27237.
6. Nipple end G shall be in accordance with MS27239.
7. Break all sharp edges and remove all burrs and slivers.
8. Part or Identifying Number (PIN).
FIGURE 1. Nipple dimensions and configuration - continued.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business