MS27068D
REQUIREMENTS
Elbow subassembly illustration, see figure 1.
Intended use. This part is a component of MS27060.
Materials. Material and material codes see table I. See applicable specification sheet and MIL-DTL-27272 for material of other components identified in table II for their material requirements.
TABLE I. Materials and PIN codes.
Material code |
Material |
Blank |
Combination of aluminum alloy and corrosion-resistant steel (CRES) |
C |
CRES |
TABLE II. Elbow subassembly composition. 1/ 2/
Size and material code |
Wire size and material code |
Union, nipple size and material code |
Elbow, nipple end size and material code |
A ±.020 inch (mm) |
B ±.020 inch (mm) |
MS27072 3/ |
M27071 3/ |
MS27086 3/ |
|||
-3/-4 4/ |
-4C |
-4C |
-3/-4C |
.845 (21.46) |
.530 (13.46) |
-3/-4C 4/ |
|||||
-4 |
-4C |
-4C |
-4C |
.845 (21.46) |
.580 (14.73) |
-4C |
|||||
-5 |
-5C |
-5C |
-5C |
.900 (22.86) |
.655 (16.64) |
-5C |
|||||
-6 |
-6C |
-6C |
-6C |
.965 (24.51) |
.720 (18.29) |
-6C |
|||||
-8 |
-8C |
-8C |
-8D 5/ |
1.235 (31.37) |
.830 (21.08) |
-8C |
|||||
-8C |
1/ Dimensions are in inches.
2/ Metric equivalents are given for general information only.
3/ MS27071, MS27072 and MS27086 shall be dry film lubricated in accordance with table III, dry film shall be applied in accordance with MS27071 or MS27086 as applicable.
4/ Swivel nut and sealing surface of this elbow subassembly shall mate with SAE-AS4395-3 fitting. The remaining portion of the subassembly shall mate with M27267-4 hose.
5/ Material code "D" aluminum alloy.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business