MS27066F
REQUIREMENTS
Elbow subassembly illustration. See figure 1. Intended use. This part is a component of MS27058.
Materials. Material and material codes see table I. See applicable specification sheet and
MIL-0TL-27272 for material of other components identified in table II for their material requirements.
TABLE I. Materials and material codes.
Material code |
Material |
Blank |
Combination of aluminum alloy and corrosion-resistant steel (CRES) |
C |
CRES |
Finish: Finishes are performed at component level. Corrosion-resistant steel, do not passivate.
Aluminum alloy. Anodize in accordance with MIL-A-8625, type II, dye blue.
TABLE II. Elbow subassembly composition. 1/ 2/
|
Size and material code |
Wire size and material code |
Union, nipple size and material code |
Elbow, nipple end size and material code |
A 5/ ±.035 (0.89) inch (mm) |
B 5/ ±.035 (0.89) inch (mm) |
MS27072 3/ |
MS27071 3/ 4/ |
MS27082 3/ 4/ |
|||
-8C |
-8C |
-8C |
-8C |
1.135 (28.83) |
.892 (22.66) |
-8 |
-80 |
||||
-10C |
-10C |
-10C |
-10C |
1.315 (33.04) |
.896 (22.76) |
-10 |
-100 |
-100 |
|||
-12C |
-12C |
-12C |
-12C |
1.808 (45.92) |
1.156 (29.36) |
-12 |
-120 |
-120 |
|||
-16C |
-16C |
-16C |
-16C |
1.901 (48.29) |
1.282 (32.56) |
-16 |
-160 |
-160 |
|||
-20C |
-20C |
-20C |
-20C |
2.180 (55.37) |
1.500 (38.10) |
-20 |
-200 |
-200 |
|||
-24C |
-24C |
-24C |
-24C |
2.500 (63.5) |
1.688 (42.88) |
-24 |
-240 |
-240 |
1/ 0imensions are in inches.
2/ Metric equivalents are given for information only.
3/ MS27071, MS27072, and MS27082 shall be dry film lubricated in accordance with table III, dry film is applied in accordance with MS27071, MS27072, or MS27082 as applicable.
4/ Material code "0" aluminum alloy.
5/ See figure 1.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business