MS270620
REQUIREMENTS:
Nipple subassembly illustration. See figure 1. Intended use. This part is a component of MS27054.
Materials. Material and material codes see table I. See applicable specification sheet and
MIL-0TL-27272 for material of other components identified in table II for their material requirements.
TABLE I. Materials and material codes.
Material code |
Material |
Blank |
Combination of aluminum alloy and corrosion-resistant steel (CRES) |
C |
CRES |
TABLE II. Adapter assembly composition. 1/ 2/
Size and material code |
Wire size and material code |
Union, nipple size and material code |
Nipple size and material code |
A 5/ ref inch (mm) |
MS27072 3/ |
MS27071 3/ 4/ |
MS27076 3/ 4/ |
||
-8C |
-8C |
-8C |
-8C |
1.197 (30.40) |
-8 |
-80 |
|||
-10C |
-10C |
-10C |
-10C |
1.252 (31.80) |
-10 |
-100 |
-100 |
||
-12C |
-12C |
-12C |
-12C |
1.432 (36.37) |
-12 |
-120 |
-120 |
||
-16C |
-16C |
-16C |
-16C |
1.463 (37.16) |
-16 |
-160 |
-160 |
||
-20C |
-20C |
-20C |
-20C |
1.522 (38.66) |
-20 |
-200 |
-200 |
||
-24C |
-24C |
-24C |
-24C |
1.625 (41.28) |
-24 |
-240 |
-240 |
1/ 0imensions are in inches.
2/ Metric equivalents are given for general information only.
3/ MS27071, MS27072, and MS27076 shall be dry film lubricated in accordance with table III, dry film is applied in accordance with MS27071, MS27072, or MS27076 as applicable.
4/ Material code "0" is aluminum alloy.
5/ See figure 1.
MS27071, MS27072, and MS27076 parts shall be coated with the same type of dry film lubricant as indicated in the PIN, no mixing of dry film lubricants shall be used on an assembly unless it is of the types specified by the "blank" designator.
NOTE: Avoid using graphite dry film lubes with aluminum nipples because in a wet environment, graphite becomes corrosive to the aluminum.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business