MS24588C
Dash number |
K inches (mm) |
L inches (mm) |
M inches (mm) |
N ±.25° |
P (see note 5) |
PD |
S inches (mm) |
-3 |
.270 (6.86) |
.255 (6.48) .235 (5.97) |
.128 (3.25) .123 (3.12) |
5° |
.234-32 UNS-2A |
.2131 .2100 |
.010 (.25) .005 (.13) |
-4 |
.200 (5.08) |
.305 (7.75) .285 (7.24) |
.175 (4.45) .170 (4.32) |
4.5° |
.281-32 UNS-2A |
.2597 .2565 |
.015 (.38) .009 (.23) |
-5 |
.280 (7.11) |
.365 (9.27) .345 (8.76) |
.237 (6.02) .232 (5.89) |
4° |
.365-28 UNS-2A |
.3398 .3365 |
.020 (.51) .010 (.25) |
-6 |
.260 (6.60) |
.445 (11.30) .425 (10.80) |
.300 (7.62) .295 (7.49) |
4° |
.421-28 UNS-2A |
.3968 .3932 |
|
-8 |
.480 (12.19) |
.580 (14.73) .560 (14.22) |
.394 (10.01) .390 (9.91) |
4.5° |
.562-24 UNEF-2A |
--- |
|
-10 |
.515 (13.08) |
.690 (17.53) .670 (17.02) |
.488 (12.40) .484 (12.29) |
5° |
.687-24 UNEF-2A |
--- |
|
-12 |
.590 (14.99) |
.860 (21.84) .840 (21.34) |
.612 (15.54) .608 (15.44) |
4° |
.812-20 UNEF-2A |
--- |
NOTES
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Unless otherwise specified, tolerances are as follows: Angles ±.5°; decimals ±.005 inch (0.13 mm).
4. Unless otherwise specified, maximum surface roughness shall be 125 µin Ra in accordance with
ASME 846.1.
5. Threads shall be in accordance with MIL-S-7742.
6. 8reak all sharp edges and remove all hanging burrs and slivers.
7. Part or Identifying Number (PIN).
FIGURE 1. Nipple dimension and configuration - Continued.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business