INCH-POUND
MIL-DTL-8789F
19 April 2007
SUPERSEDING
MIL-DTL-8789E
6 April 2001
DETAIL SPECIFICATION
FITTING END, ATTACHABLE, HYDRAULIC, HIGH PRESSURE (3,000 PSI),
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments and
Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers the requirements for fitting end, attachable, hydraulic pressure
(3000 psi).
1.2 Part or Identifying Number (PIN). The PIN consists of the letters MS (see 3.4), the basic
specification number, and a dash for fitting size.
PIN:
MS
28760
-4
Fitting size
Basic specification number
MS prefix
2. APPLICABLE DOCUMENTS
specification. This section does not include documents cited in other sections of this specification or
recommended for additional information or as examples. While every effort has been made to ensure the
completeness of this list, document users are cautioned that they must meet all specified requirements
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and
handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the
issues of these documents are those cited in the solicitation or contract.
Comments, suggestions, or questions on this document should be addressed to: Defense Supply
Center, Columbus, Attn: DSCC-VAI, P.O. Box 3990, Columbus, OH 43218-3990, or emailed to
Construction@dscc.dla.mil. Since contact information can change, you may want to verify the currency
of this address information using the ASSIST Online database at https://assist.daps.dla.mil.
AMSC N/A
FSC 4730
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business