MS39199 Nipple, Tube-Safety Sleeve Compression

Pages 1 - 2 - 3 - 4

MS39199G

REQUIREMENTS:

Dimensions and configuration: See figure 1. Nipples. See table I.

Tolerances: Unless otherwise specified, decimals ±.005, fractions ±1/64, degrees ±2°. Threads: The threads shall be in accordance with FED-STD-H28.

Material:

Code	Material:
C	Carbon Steel bar, type AISI-C-1112, C-1113, C-1117, C-1118 or C-1137 in accordance with SAE AIR4127.
F	Alloy steel in accordance with SAE AIR4127.
S	Corrosion resistant steel in accordance with SAE AMS5659, SAE AMS5862, or, alloy 15-5 PH in accordance with ASTM A564/A564M type XM-12 or UNS S15500 or SAE AMS 5665.

Finish:

Code	Chemical Finish;
C	Carbon steel: Cadmium in accordance SAE AMS-QQ-P-416, type II, class 3, 200µ inches to 300µ inches (5.08 µm to 7.62 µm) thick.
F	Alloy steel. Cadmium in accordance SAE AMS-QQ-P-416, type II, class 3, 200µ inches to 300µ inches (5.08 µm to 7.62 µm) thick.
S	Corrosion resistant steel: Passivate in accordance with SAE AMS2700, type 6 or 7.
Z	Steel, alternative chem finish: in accordance with ASTM 8633, type VI, FeZn 25.

Part or Identifying Number (PIN) example: (PIN covers the complete item with nuts and sleeves.)

MS 27612 -8 C Z

If finish code same as material code, then use only one code.

Material code

Dash size

Specification number

MS prefix

Guidance on use of alternative parts with less hazardous or non-hazardous materials. This specification provides an alternate material, zinc finish via the PIN. Users should select the PIN with the least hazardous material that meets the form, fit, and function requirements of their application.

Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the

Source: https://assist.dla.mil -- Downloaded:

Check the source to verify that this is the current version before use.