MS39136H
NOTES:
1. All dimensions are in inches.
2. Metric equivalents are given for information only.
3. For design feature purposes, this document takes precedence over acquisition documents referenced herein.
4. In the event of a conflict between the text of this specification sheet and the references cited herein, the text of this specification sheet shall take precedence.
FIGURE 1. Compression sleeve - Continued. REQUIREMENTS:
Sleeves shall be specified on figure 1.
The sleeves specified herein are a component of the adapter, straight pipe to hose, automotive air brake hose
MS39133.
Materials shall conform to formed rod, tempered, half-hard brass as specified in ASTM-816/816M. Finish shall be uncoated.
Tolerances for the compression sleeve, unless otherwise specified, are as follows:
xxx = ±.005 xx = ±.002
Angles ±2°
8uttress threads shall be in accordance with FED-STD-H28/14 and ASME-81.9. Part or Identifying Number (PIN).
Example of a PIN: MS39136-1
Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes
no liability whatsoever for any inaccuracies in these notations. 8idders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue.
Referenced documents. This document references the following:
MS39133
FED-STD-H28/14
ASME-81.9
ASTM-816/816M
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business