MS27627B
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Unless otherwise specified, tolerances for three place decimals are ±.005 inch (0.13 mm).
4. Dimensioning and tolerancing are in accordance with ASME Y14.5M.
5. On -4, -6, and -8 sizes, dimension A shall be used when the adjacent diameter to the left of plane B- B is greater than dimension J. When the adjacent diameter is equal to or less than dimension J, dimension M may be used in place of dimension A.
8. All burrs and slivers shall be removed.
FIGURE 1. Elbow, flared, 90o, dimensions and configuration- Continued.
REQUIREMENTS:
Dimensions and configurations: The design, construction, and physical dimensions shall be in accordance with MIL-DTL-83296 and figure 1, in case of conflict between this specification sheet and MIL-DTL-83296, this specification sheet shall govern.
This is a design specification sheet for manufacturing purposes. The item is only procured as an integral part of adapter assembly MS27621.
This part for use with MIL-DTL-83298 hose and hose assemblies in accordance with
MIL-DTL-32330.
Material: Material shall be a corrosion resistant steel (CRES), class 304 in accordance with
SAE-AMS5639, 304L in accordance with SAE-AMS5647, 316 in accordance with SAE-AMS5648, or
321 in accordance with SAE-AMS5645, or condition A (accepted classes only), in accordance with
ASTM A276.
Any forged design fitting is acceptable for -4, -6, and -8 sizes. Any bent tube design fitting is acceptable for -10 size.
Finish: Finish shall be passivated in accordance with MIL-DTL-83296. PIN example:
MS27627 -4 C
Material (C for CRES)
Dash size (see figure 1)
Specification sheet number
MS prefix
PIN example: MS27627-4C indicates a 90° elbow 1/4 inch, CRES.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business