MS27386C
REQUIREMENTS
Nipple subassembly illustration, see figure 1.
Intended use. This part is a component of MS27381.
Materials. Material and material codes see table I. See applicable specification sheet and MIL-0TL-27272 for material of other components identified in table II for their material requirements.
TABLE I. Materials and material codes.
Material code |
Material |
Blank |
Combination of aluminum alloy and corrosion-resistant steel (CRES) |
C |
CRES |
Finish: Finishes are performed at the component level.
CRES: CRES do not passivate.
Aluminum alloy. Anodize in accordance with MIL-A-8625, type II, dye yellow.
TABLE II. Nipple subassembly composition. 1/ 2/
Size and material code |
Nipple size and material code |
A ref inch (mm) |
MS27391 3/ 4/ |
||
-3/-4C 5/ |
-3/4C |
.871 (22.12) |
-4C |
-4C |
.825 (20.96) |
-5C |
-5C |
.863 (21.92) |
-6C |
-6C |
.948 (24.08) |
-8 |
-80 |
1.087 (27.61) |
-8C |
-8C |
|
-10 |
-100 |
1.230 (31.24) |
-10C |
-10C |
|
-12 |
-120 |
1.288 (32.72) |
-12C |
-12C |
|
-16 |
-160 |
1.434 (36.42) |
-16C |
-16C |
|
-20 |
-200 |
1.556 (39.52) |
-20C |
-20C |
|
-24 |
-240 |
1.881 (47.78) |
-24C |
-24C |
1/ 0imensions are in inches.
2/ Metric equivalents are given for general information only.
3/ MS27391 shall be dry-film lubricated in accordance with
MS27391, see table III.
4/ Material code "0" aluminum alloy.
5/ Swivel nut and sealing surface of this nipple subassembly shall mate with SAE-AS33514-3 fitting. The remaining portion of the subassembly shall mate with M27267-4 hose.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business