MS27238 Wire, Nut Retaining, Designed For Adapter, Hose To Tube, Reusable, Hydraulic, Fuel And Oil Lines

Pages 1 - 2 - 3

MS27238B

NOTES:

1. Dimensions are in inches.

2. Metric equivalents are given for information only.

3. Wire shall be straight within .020 inch (0.51 mm) total indicator reading.

4. Unless otherwise specified, maximum surface roughness shall be 125 µin Ra in accordance with

ASME B46.1.

5. Wire shall be free from scale, burrs, and slivers.

FIGURE 1. Wire dimensions and configuration - Continued.

REQUIREMENTS:

Dimensions and configurations: The design, construction, and physical dimensions shall be in accordance with MIL-DTL-5070 and figure 1 in case of conflict between this drawing and

MIL-DTL-5070, this drawing shall govern.

Intended use. This wire is to be used with MS27223 and MS27225. This item shall not be procured for stocking purposes.

Materials: Materials shall be in accordance with MIL-DTL-5070. Finish: Finish in accordance with MIL-DTL-5070.

Color identification: Color identification shall be in accordance with MIL-DTL-5070.

Part or Identifying Number (PIN) example:

MS 27238 -24 CZ

Material/finish designator, see table I Dash number on figure 1

Specification number

MS prefix

TABLE I. Code for material and finish.

Code	Dash size	Material/finish
CC	-4 through -6	Carbon Steel - cadmium plating
CZ	-4 through -6	Carbon steel - zinc plating
SS	-4 through -6	Corrosion resistant steel - N/A
AA	-8 through -32	Aluminum - anodic coating
TA	-4 through -32	Titanium - anodized or fluoride phosphated.

To the users of this document, it is recommended that the use of carbon steel material with cadmium plating be used only when the other materials and finishes specified in this document cannot meet performance requirements.