MS270610
REQUIREMENTS:
Nipple subassembly illustration, see figure 1. Intended use. This part is a component of MS27053.
Materials. Material and material codes see table I. See applicable specification sheet and
MIL-0TL-27272 for material of other components identified in table II for their material requirements.
TABLE I. Materials and material codes.
Material code |
Material |
Blank |
Combination of aluminum alloy and corrosion-resistant steel (CRES) |
C |
CRES |
TABLE II. Nipple subassembly composition. 1/ 2/
Size and material code |
Nipple size and material code 3/ 4/ |
A ref inch (mm) |
MS27075 |
||
-3/-4C 5/ |
-3/-4C |
.655 (16.64) |
-4C |
-4C |
.670 (17.02) |
-5C |
-5C |
.700 (17.78) |
-6C |
-6C |
.745 (18.92) |
-8 |
-80 |
.860 (21.84) |
-8C |
-8C |
1/ 0imensions are in inches.
2/ Metric equivalents are given for general information only.
3/ MS27075 shall be dry film lubricated in accordance with table III, dry film shall be applied in accordance with MS27075.
4/ Material code "0" aluminum alloy.
5/ Swivel nut and sealing surface of this nipple subassembly shall mate with SAE-AS4395-3 fitting.
The remaining portion of this subassembly shall mate with M27267-4 hose.
Finishes: Finishes are performed at component level.
Corrosion resistant steel do not passivate.
Aluminum alloy, anodize in accordance with MIL-A-8625, type II, dye blue
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business