MS24590C
Dash number |
X rad Inches (mm) ±.015 (0.38) |
Y dia inches (mm) |
AA inches (mm) |
BB inches (mm) |
CC rad inches (mm) |
DD rad inches (mm) |
EE inches (mm) |
-3 |
.109 (2.77) |
.500 (12.70) |
.0500 (1.270) |
.1000 (2.540) |
.0200 (.508) |
.025 (.64) |
.445 (11.30) |
-4 |
.530 (13.46) |
.505 (12.83) |
|||||
-5 |
.125 (3.18) |
.640 (16.26) |
.0625 (1.59) |
.1250 (3.18) |
.0275 (.70) |
.032 (.81) |
.600 (15.24) |
-6 |
.720 (18.29) |
.665 (16.89) |
|||||
-8 |
.820 (20.83) |
.810 (20.57) |
|||||
-10 |
.188 (4.78) |
1.000 (25.40) |
.0715 (1.82) |
.1430 (3.63) |
.0310 (.79) |
.040 (1.02) |
1.000 (25.40) |
-12 |
1.145 (29.08) |
.0714 (1.81) |
.1428 (3.63) |
1.160 (29.46) (29.46 (748.28)) |
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are for information only.
3. Unless otherwise specified, tolerances are as follows: Angles ±1°; decimals ±.005 inch (0.13 mm).
4. Unless otherwise specified, maximum surface roughness shall be 125 µin Ra in accordance with
ASME B46.1.
5. Threads shall be in accordance with MIL-S-7742, except round threads.
6. Break all sharp edges and remove all hanging burrs and slivers.
7. Thread marks on diameter E shall not be cause for rejection.
8. Part or Identifying Number (PIN).
REQUIREMENTS:
FIGURE 1. Socket dimensions and configuration - Continued.
Dimensions and configurations: The design, construction, and physical dimensions shall be in accordance with MIL-DTL-5070 and figure 1 in case of conflict between this drawing and
MIL-DTL-5070, this drawing shall govern.
Intended use. This part is a component of MS24587, MS27224, MS27226, MS27228, MS27230, and
MS27232.
Materials. Materials shall be in accordance with MIL-DTL-5070. Finish. Finish shall be in accordance with MIL-DTL-5070.
Color identification: Color identification shall be accordance with MIL-DTL-5070.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business