MS20756F
Size number |
K dia (see note 8) ±.015 (±0.38) inches (mm) |
L dia Ref inches (mm) |
p number of holes |
56 |
5.562 (141.27) |
4.875 (123.83) |
8 |
64 |
6.125 (155.58) |
5.438 (138.13) |
|
80 |
7.125 (180.98) |
6.438 (163.53) |
10 |
96 |
8.125 (206.38) |
7.438 (188.93) |
12 |
112 |
9.188 (233.38) |
8.500 (215.90) |
14 |
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for information only.
3. Unless otherwise, tolerances, ±.005 inch (0.13 mm), angles ±.5°.
4. Diameters C and D shall be concentric within .010 inch (0.25 mm) full indicator movement.
5. Unless otherwise specified, the surface roughness shall not exceed 100 microinches (2.54 µm) Ra in accordance with ASME 846.1.
6. 8reak all sharp edges; remove all loose or hanging burrs and slivers that may become dislodged.
7. Maximum operating temperature 275°F (135°C), maximum pressure 500 psi (3.4 Mpa).
8. Reduction by forging draft angle of 7° maximum is permissible if forged.
FIGURE 3. Swivel fitting flange round size 56 through 112 - Continued. REQUIREMENTS:
Design and construction:
Dimensions and configuration: See figures 1, 2, and 3. For nominal use on fuel and oil systems.
Materials. Materials and designators shall be in accordance with SAE-AS4875.
Material and size designators shall be in accordance with table I.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business