Notes to the figure 1.
MS17835F
1. Unless otherwise specified on the drawing, remove burrs and break sharp edges to
.003 - .015 R.
2. Dimensions are in inches. Unless otherwise specified, tolerances: decimals + .010, angles + 0.5o.
3. Unless otherwise specified on the drawing, all machined fillets to be .020 R.
REQUIREMENTS:
Material: Corrosion Resistant Steel (18-8), AISI Type 321, in accordance with specifications SAE-AMS5510 or SAE-AMS5512. Passivate in accordance with SAE-AMS-QQ-P-35 after machining.
Finish: All exposed surface roughness shall be 125 micro-inches Ra maximum in accordance with ASME - B46.1.
Porosity test: Finished connector shall not leak when subjected to 100 PSI air pressure and submerged in water for 3 minutes.
Notes:
1 In the event of a conflict between the text of this specification sheet and the references cited herein, the text of this specification sheet shall take precedence.
2. Referenced documents shall be of the issue in effect on the date of invitation for bid.
Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue on Form DD 672-1. In this revision, the previous MS standard is reformatted to military specification sheet in accordance with MIL-STD-961D.
CONCLUDING MATERIAL
Custodians: Preparing activity: Army - AV Navy - AS
Navy - AS
Air Force - 99 (Project: 4730 - 2344)
Review activities: Army - AT
Navy - MC, SA
Air Force - 71
DLA - CC
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business