MS17834E
Notes to the figure 1.
1. Remove burrs and break sharp edges to .003 -.015 R.
2. Dimensions are in inches. Unless otherwise specified on the drawing, tolerance: decimals
+ .010, angles + 0.5o.
3. Unless otherwise specified on the drawing, all machined fillets to be .020 R.
REQUIREMENTS:
Material: Corrosion Resistant Steel (18-8), AISI Type 303 in accordance with SAE-AMS5640, ASTM-A484, or ASTM-A582.
Finish: Clean and descale in accordance with ASTM-A380 and passivate in accordance with
SAE-AMS-QQ-P-35 after machining.
Surface roughness: Maximum roughness 125 micro-inches Ra on all machined surfaces in accordance with ASME-B46.1.
Porosity test: Finished fitting shall not leak when subjected to 100 PSI air pressure and submerged in water for 3 minutes.
Notes:
1. In the event of a conflict between the text of this specification sheet and the references cited herein, the text of this specification sheet shall take precedence.
2. Referenced documents shall be of the issue in effect on the date of invitation for bid.
Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue on DD Form 672-1. In this revision, the previous MS standard is reformatted to military specification sheet to be in accordance with MIL-STD-961D.
CONCLUDING MATERIAL
Custodians: Preparing activity: Army - AV Navy - AS
Navy - AS
Air Force - 99 (Project: 4730-2348)
Review activities: Army - AT
Navy - MC, SA
Air Force - 71
DLA - CC
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business