MIL-S-27661C
Strainers shall be packaged in accordance with the con-
5.1.2 Level C.
tractor's commercial practice.
Packing shall be level A, B or C as specified (see 6.2).
5.2
Packing.
*
Shipping containers shall conform to the export-type
5.2.1 Level A.
requirements of PPP-B-576, PPP-B-585, PPP-B-591, PPP-B-601, PPP-B-621,
Closure and strapping shall be in accordance with
PPP-B-636, or PPP-B-640.
the applicable container specification or appendix. Tape conforming to
PPP-T-97 may be used in lieu of steel strapping for fiberboard containers only.
When the container or packaging material immediately within the exterior con-
tainer is not waterproof, a case liner shall be provided, or if a water-
resistant fiberboard container conforming to PPP-B-636 is used, all openings
may be sealed with tape conforming to A-A-884, A-A-1586 and A-A-1830 to pro-
Sealed case liners shall conform to the require-
vide needed waterproofness.
ments of MIL-L-10547 and appendix or as an alternate, material meeting the
requirements of PPP-B-1055 may be used. The seams, joints, and closure shall
be equal to the waterproofness of the material itself. When adhesive material
is used for sealing the joints and closure, the material shall conform to MMM-
A-260.
Shipping containers, closure, and strapping shall be in
5.2.2 Level B.
accordance with the domestic requirements of the container specifications
listed in 5.2.1.
5.2.3 Level C.
Strainers shall be packed to insure safe delivery at the
lowest cost for packing and transportation charged combined.
5.3 Marking.
In addition to any special marking required by the contract
or order, unit packages, intermediate packages, and shipping containers shall
The shipment
be marked in accordance with the requirements of MIL-STD-129.
marking shall be:
Strainer,
Sediment, Fuel Servicing Unit, 600 GPM
6.
NOTES
6.1 Intended use.
The strainer is intended for use as an integral part of
a gasoline or jet fuel dispensing system, for installation on fuel servicing
units.
6.2
Ordering data.
Procurement documents should specify the following:
a.
Title, number, and date of this specification.
b.
Type piping connections required (see 1.2 and 3.7.1.1).
c.
Location of drain plug (see 3.7.1).
d.
Selection of applicable levels of preservation and packaging, and
packing (see 5.1 and 5.2).
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business