MIL-DTL-27272C
ASTM D471
-
Rubber Property-Effect of Liquids (DoD adopted)
ASTM E1742
-
Radiographic Examination (DoD adopted)
(Application for copies should be addressed to ASTM International, PO Box C700, 100 Barr Harbor
Drive, West Conshohocken, PA 19428-2959.)
NATIONAL CONFERENCE OF STANDARDS LABORATORIES (NCSL)
ANSI/NCSL Z540-1
-
General Requirements for Calibration Laboratories and Measuring and
Test Equipment (DoD adopted)
rd
(Application for copies should be addressed to the American National Standards Institute, 25 West 43
th
Street, 4 Floor, New York, New York, 10036.)
SAE INTERNATIONAL
SAE AMS-QQ-P-35
-
Passivation Treatments for Corrosion-Resistant Steel (DoD adopted)
SAE ARP908
-
Hose and Tube Fitting, Installation and Qualification Test Torque
Requirements (DoD adopted)
SAE AS1701
-
Lubricant, Solid Film (DoD adopted)
SAE AS2078
-
Test Methods, Hose Assemblies, Polytetrafluoroethylene (PTFE) (DoD
adopted)
SAE AMS-STD-2219
-
Fusion Welding for Aerospace Applications (DoD adopted)
SAE AMS 2672
-
Brazing Aluminum Torch or Aluminum (DoD adopted)
SAE AMS 2673
-
Brazing, Aluminum and Aluminum Alloys Molten Flux (Dip)
SAE AS4395
-
Fitting End - Flared Tube Connection, Design Standard (DoD adopted)
SAE AS5272
-
Lubricant, Solid Film, Heat Cured, Corrosion Inhibiting Procurement
Specification
SAE AS33514
-
Fitting End, Standard Dimensions for Flareless Tube Connection and
Gasket Seal (DoD adopted)
(Application for copies should be addressed to SAE International, 400 Commonwealth Drive,
Warrendale, PA 15096-0001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein (except for related specification sheets), the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in
accordance with the applicable specification sheet. In the event of any conflict between the requirements
of this specification and the specification sheet, the latter shall govern.
3.2 Qualification. Fittings furnished under this specification shall be products that are authorized by the
qualifying activity for listing on the applicable qualified products list (QPL) before contract award (see 4.4
and 6.3).
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business