A-A-50632A(SH)
FLUID CONTROL INSTITUTE (FCI)
78-1 - Pressure Rating Standard for Pipeline Strainers Other than
"Y" Type.
(Application for copies should be addressed to the Fluid Control Institute, Inc., P.O. Box 3854, Tequesta, FL 33458.)
INSTRUMENT SOCIETY OF AMERICA (ISA)
S75.02 - Control Valve Capacity Test Procedure.
(Application for copies should be addressed to the Instrument Society of
America, 67 Alexander Dr., P.O. Box 12277, Research Triangle Park, NC 27709.)
SOCIETY OF AUTOMOTIVE ENGINEERS (SAE)
J 1926 - Specification for Straight Thread O-ring Boss Port.
(Application for copies should be addressed to the Society of Automotive
Engineers Inc., 400 Commonwealth Drive, Warrendale, PA 15096-0001)
(Non-Government standards and other publications are normally available from the organizations that prepare or distribute the documents. These documents also may be available in or through informational service.)
7.2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited herein the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
7.3 Technical documents. Unless otherwise specified, a technical manual shall be provided. The technical content of these manuals should include sufficient technical details to enable a repair, maintenance, or overhaul activity to restore the equipment dimensions, clearances, and tolerances such that the equipment is capable of perform- ing its function as originally specified and is capable of being logistically supported by the DoD logistics support system.
7.4 Sub-contracted material and parts. The packaging or delivery preparation requirements of referenced documents listed in section 7.2 do not apply when material and parts are acquired by the contractor for incorporation into the equipment and lose their separate identity when the equipment is shipped.
7.5 Ordering spare or repair parts. When ordering spare parts or repair parts for the equipment covered by this commercial item description, the contract should state that such spare parts and repair parts should meet the same requirements and quality assurance provisions as the parts used in the manufacture of the equipment. Packaging for such parts should also be specified.
7.5.1 Repair parts and repair parts boxes. Complete sets of repair parts elements for each type and class shall be furnished as follows:
(a) One set elements for each of the ten initial strainers supplied. (b) One set elements for each two additional strainers supplied.
(c) Cover gaskets - four for every strainer supplied.
(d) Other gaskets, seals and springs - one set for every ten strainers
supplied.
When specified (see 7.1) items (c) and (d) shall be furnished in repair boxes.
7.6 Preinstallation instruction. A set of instructions covering the preinstallation of the equipment should be furnished. Instructions should include all information necessary to return the unit to active status, such as, but not limited to: the addition of lubricants prior to operation,
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business